Page tree
Skip to end of metadata
Go to start of metadata

Where To Find This Example

AWR Version 14

This example was named in V14, please see Bridge_T_Attenuator

AWR Version 13

Understanding AWR .emz Files

Design Notes

BRIDGE-T ATTENUATOR

This project shows a variable bridge-T attenuator implemented with ideal resistors. It demonstrates how to access a data file which contains a table of resistor values for various attenuation states. This method of using a state table to set element parameters can be used for other variable circuits such as phase shifters.

Overview

The "Bridge_T" schematic contains the attenuator design. In it, the two resistors labeled "R1" and "R4" determine the attenuation of the circuit. The values of "R1" and "R4" are specified as a matrix in the data file "Resistor_Values", and are easily varied by changing the variable "state" which corresponds to the attenuation states.

Referencing the Data File

The matrix represented by the data file "Resistor_Values" is assigned to variable "dfile" in the schematic "Bridge_T" using the DataFile() function:

dfile = DataFile("Resistor_Values")

Each row of the "dfile" matrix represents an attenuation state, and can be assigned to another variable "Rvector" using the row() function:

Rvector=row(dfile,state)

where "state" is an index variable corresponding to the row position in the matrix. The values of "R1" and "R4" correspond to the third and fourth column "dfile", and also correspond to the third and fourth element of "Rvector" for each "state":

R1 = Rvector[3]

R2 = Rvector[4]

By simply changing the value of "state", the values of "R1" and "R4" are both changed concurrently.

See Text Data File Format in the Data Files Chapter of the MWO/AO/VSS User Guide for more information regarding the data file format.

Simulation

The attenuation results for "state=5" is plotted on graph "Attenuation". To see results for all attenuation states, enable the SWPVAR element.

Schematic - Bridge_T

Graph - Attenuation