Page tree
Skip to end of metadata
Go to start of metadata

Where To Find This Example

AWR Version 14.01

Select Help > Open Examples... from the menus and type either the example name listed above or one of the keywords below.

Or you can open the project directly from this page using this button. Make sure to select the Enable Guided Help before clicking this button.

AWR Version 13

This example is not available for AWR Version 13 or earlier.

Design Notes

Conformal Antenna

In this example an antenna generated by AntSyn was imported as an arbitrary 3D Analyst structure, wrapped around a cylinder and the results compared to the original.

Download

Simulating this project is time-consuming.  This example, with the datasets included, is available at:  http://kb.awr.com/display/examples/Conformal_Antenna

Setup

The AntSyn Antenna EM structure is the original antenna that was generated by AntSyn.  This antenna is a mesh antenna.

  You can see the antenna pattern by simulating the structure and making sure the annotation is enabled.  The original antenna was then copied as the starting point of the wrapped antenna.

Analyst has the feature to wrap and thicken wrapped sheets.  This is done by using AWRDE's 3D Editor.  To wrap a sheet place a cylinder so that it is tangential to the sheet that you would like to wrap.  Click on the Modify Solids button and select Wrap Sheet.  Select the sheet click enter, and then select the cylinder and click enter again.  Once you finish wrapping the sheet you can thicken it by going to the modify solids menu, selecting Thicken Sheet, selecting the wrapped sheet, and clicking enter.

AntSyn

AntSyn was used to generate the antenna that is used in this example.  AntSyn is a powerful antenna design tool that can automate the antenna design process.  Read more about its capabilities here, https://awrcorp.com/support/help.aspx?id=101.