Page tree
Skip to end of metadata
Go to start of metadata

Where To Find This Example

AWR Version 14

This example was named in V14, please see Magnitude_Estimator_Fixed_Point

AWR Version 13

Select Help > Open Examples... from the menus and type either the example name listed above or one of the keywords below.

Or in Version 13 you can open the project directly from this page using this button.

Design Notes

Fixed-Point Magnitude Calculation

This example demonstrates a magnitude estimator whose hardware complexity is much simpler and faster than that of the full-precision exact calculation using a square-root operation. Magnitude estimators are used in many fixed-point ASIC designs for received signal strength indicators (RSSI) and demodulation algorithms.

The magnitude of a complex number, I + jQ, is defined as sqrt(I^2 + Q^2) and is approximated as:

Mag ~= A * max(|I|,|Q|) + B * min(|I|,|Q|)

where A and B are two constants whose values can be set such that either the RMS error, peak error and/or implementation complexity is reduced within acceptable levels. Some of the most common values for A and B are given below, together with the associated errors:

A B Average Error RMS Error Peak Error

(linear) (dB) (dB)

1.0 0.5 -0.086775 -20.7 -18.6

1.0 0.25 0.006456 -27.6 -18.7

1.0 0.4 -0.049482 -25.1 -22.3

0.94754 0.39248 0.000547 -32.6 -25.6 (min RMS error)

0.96043 0.39782 -0.013049 -31.4 -28.1 (min peak error)

Note that the first two choices are very simple to implement in hardware (using shifts and adds), while the others are more complex.

This project calculates the magnitude of the input in three different ways:

1. The exact calculation uses a CMAG block to compute the magnitude of a complex input.

2. The floating-point approximation uses the algorithm above and double-precision arithmetic.

3. The fixed-point approximation uses fixed-point arithmetic for the algorithm above. In this case, bit and decimal widths should be selected such that loss of information due to the real to fixed-point conversion is within acceptable limits. For example, the bit and decimal widths for the SCALE parameter in the SCALE_FP block should be set such that the selected values for A and B are represented by these widths.

System Diagram - System Diagram 1

Graph - Input Signal

Graph - Magnitude