Page tree
Skip to end of metadata
Go to start of metadata

Where To Find This Example

Select Help > Open Examples... from the menus and type either the example name listed above or one of the keywords below.

Or in Version 13 or higher you can open the project directly from this page using this button. Make sure to select the Enable Guided Help before clicking this button.

Design Notes

Measurements:

According to ETSI TS 125 141 V7.11.0 (2008-04) Technical Specification

- 6.5.3  Spurious Emissions

Results are displayed in Spurious Emissions graph.  Emission mask in Table 6.24 is stored in file SpurEmissionsMask in the project tree.

-------------------------------------------------------

WCDMA/HSDPA TX Conformance Testing

According to 3GPP TS 25.141 V6.10.0

Test Models for TX conformance testing are selected through TestModel parameter in Global Definitions.  Multiple channel configurations available for some of the tests are selected by the ChannelConfig parameter.  In case of invalid entries, these parameters are rounded to the nearest valid value.

The rated output power, PRAT, of the base station is set by OutPowerLevel_dBm.  The nominal values are specified as follows:

The center frequency is specified by CarrierFreq_MHz. Its value should be set according to the values specified in Section 3.4 of the specification document.

Test Model configurations are specified in the tables below:

System Diagram - WCDMA_HSDPA_TestModels

Graph - Spurious Emissions