The procedure for requesting AWR support has changed. Please read all about the new AWR product support process.
Page tree
Skip to end of metadata
Go to start of metadata


What are ports in Analog Office and do I have to use them?


There are various port elements in Analog Office. Understanding their purpose and proper use will greatly speed your familiarity with Analog Office, especially if you are coming from a Cadence/SPICE background.


At RF and microwave frequencies, the distinct concepts of voltage and current become cloudy because there is usually no way to measure them without changing the circuit's performance. As a result, measurements at these frequencies have traditionally been performed using power instead of voltage and/or current because power can be measured with instruments that have very well matched, broadband inputs (vector and scalar network analyzers, power meters, spectrum analyzers, etc.). Analog Office includes many types of ports that can be used as either sources or as loads (terminations). The various types of ports will be discussed below. Note that all ports are set by default to a 50 Ohm impedance.


The PORT element is the most commonly used port. It provides the following functionality:

In hierarchical projects, a PORT element provides the interconnectivity between a lower level schematic and its next high level schematic. When PORT is used in this manner, to provide subcircuit connectivity, the impedance ("Z") parameter is ignored. It provides connectivity only. In this case, PORT is like a Cadence "terminal". Note also that explicit loads are not used for subcircuits in Analog Office. Simply attach a PORT where you want to make the higher level connection.

When used in a LINEAR top level schematic, PORT provides signal I/O points. Linear measurements can be made at these ports, such as S-Parameters, noise figure, stability, etc. When used as a signal source, the impedance ("Z") parameter is used to set the source impedance and the power is simply assumed to be low enough that the circuit behaves in a linear fashion. When used as a load, or termination, the impedance ("Z") parameter sets the impedance to ground at that point and provides a measurement point as well. Absolute measurements (power, voltage, current) can not be made with linear analysis. Note also that linear ports have an implicit ability to both send and receive power, so a measurement like S22 allows the reflected power to be separated from the incident power and measured directly at the PORT.

When used in a NONLINEAR analysis, we have to make the distinction between sources and loads. PORT provides a load for any nonlinear measurement, but it does not provide any nonlinear source capability. PORT can be used to perform linear measurements on nonlinear circuits but it can not drive any nonlinear measurements.


All remaining ports are nonlinear source ports. Their individual function can be found by searching the help for "PORT". All port names begin with "PORT", so they are all grouped in the help, making it easy to compare different elements. There are both single tone and two tone ports, there are ports that have specific waveforms associated with them, and there are ports that can provide modulated signals to the circuit. There are also waveform sources that look and behave more like traditional SPICE sources. Finally, there is a user configurable port that can behave as defined by the user - this single element (PORT_SRC) can perform as any of the other types of ports or it can be configured as needed.

Overall, there are decisions to be made in terms of the various port capabilities and the discrete voltage/current sources.


The short answer is no for top level schematics and yes for subcircuits in hierarchy. Ports are the only way to establish subcircuit connectivity for higher schematic levels. Voltage and current sources can be used at the top level and they will behave as expected. There are, however, many features available in Analog Office that are simplified by using ports.


We believe the answer is yes. Power measurements and the ability to sweep power are made much easier by using ports. Two tone excitations are trivialized by using a two tone port, and the ability to sweep the offset between the two tones is parameterized. These are just a few examples of the types of measurements that are simplified with the use of ports.