Where To Find This Example
AWR Version 15
Select Help > Open Examples... from the menus and type either the example name listed above or one of the keywords below.
Or you can open the project directly from this page using this button. Make sure to select the Enable Guided Help before clicking this button.
AWR Version 14
This example is not available for AWR Version 14 or earlier.
NR FDD Uplink TX Test Bench
This example demonstrates an NR FDD Uplink receiver test bench, compliant with the 3GPP 38 series specifications. The test bench allows user to configure the NR uplink signal source and device under test (DUT). The receiver is configured automatically to match the settings used in the transmitter.
Some of the signal parameters that the user can change include:
- Signal level, TxOutLvl_dBm, which is swept by the VSA.EVM block
- Number of resource blocks, N_RB_UL
- Carrier Frequency (MHz)
- Subcarrier spacing as allowed by NR specification
- Modulation and coding scheme, MCS, and the corresponding table, MTBST, as specified in the NR specifications
- Oversampling rate used in the simulation, OVRSMP
- PUCCH format according to Section 6.3.2 TS 38.211.
The test bench can be used to monitor various measurements. The following measurements are predefined:
- The CCDF at the input and output of DUT
- The TX signal spectrum at the input and output of DUT
- EVM %rms vs. output power, per resource block, and per subcarrier
- The impact of phase noise on EVM
- The impact of phase/amplitude and DC offset on EVM
- AM to AM characteristics of the DUT